|
|
|
|
|
|
|
|
|
|
|
|
|
|
TH 24002 is a matching combination cover in plastic and a matching die-cast crank, both in a white finish. Both cover and crank are specifically used on the EntryGard dual arm operators TH 23076 through TH 23079.
|
The H 3514 casement window operator is a left hand aluminum square body type. It has a 9 in steel arm with a round disc on the tip (some older styles had a small wheel instead of a disc). The disc slides in the H 3529 casement track located on the bottom of the casement window. It is worm gear driven by a 3/8 in crank spindle. The matching crank handle that fits onto the crank spindle and installation screws are included. Mounting holes available are 3-7/8 and 4-3/4 in apart.
|
The H 3520 casement window operator is a right handed aluminum square body type. It has a 9 in steel arm with a round disc on the tip (some older styles had a small wheel instead of a disc). The disc slides in the H 3529 casement track located on the bottom of the casement window. It is worm gear driven by a 3/8 in crank spindle. The matching crank handle that fits onto the crank spindle and installation screws are included. Mounting holes available are 3-7/8 and 4-3/4 in apart.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Replacing the old Truth Entrygard series the 23027 is a left handed, 13-1/2 in single arm operator with a baked enamel Coppertone finish. It is made of heavy-duty die-cast zinc. The steel arm, worm drive and gears are protected with a corrosive-resistant finish and it opens to a full 90 degrees. The plastic roller on the end of the arm insure a smooth operation as it slides through the TH 22397 track. When installing, the housing easily fastens down to the window sill.
|
TH 23076 is a left handed dual arm operator with a 4-1/16 in offset (up) link arm. The long continuous arm and the jointed arm create an action that pushes the sash open while pulling the hinge side of sash to the open position. This is the mechanism only - no cover or crank handle included (optional). The heavy-duty die-cast zinc operator base, worm drive, gears as well as the steel arms and stud bracket are protected with the corrosive-resistant E-Gard? coating process.
|
TH 23077 is a right handed dual arm operator with a 4-1/16 in offset (up) link arm. The long continuous arm and the jointed arm create an action that pushes the sash open while pulling the hinge side of sash to the open position. This is the mechanism only - no cover or crank handle included (optional). The heavy-duty die-cast zinc operator base, worm drive, gears as well as the steel arms and stud bracket are protected with the corrosive-resistant E-Gard? coating process.
|
|
|
